Welcome to Part 6 of the NSX-T 3.0 Lab Federation Series.In my Last Post I Setup the stretched Tier-0 gateway.In this post we will be deploying our stretched Tier-1 Gateway and connecting our test VM’s to the stretched segments. In our lab setup diagram we are going to configure the blue section downwards. From the Tier-1 perspective we […]
Month: June 2020
NSX-T 3.0 Lab: Federation Tier-0
Welcome to Part 5 of the NSX-T 3.0 Lab Federation Series.In my Last Post I Setup the RTEPs on the Edge clusters ready for the Federation networking configuration.In this post we will be deploying our shared Tier-0 Gateway. In our lab setup diagram we are going to configure the orange section and peer with our Lab Routers. From […]
NSX-T 3.0 Lab: Federation RTEP Configuration
Intro Welcome to Part 4 of the NSX-T 3.0 Lab Federation Series.In my Last Post I Setup the Global Manager and configured our Locations DCA and DCB. In this post we will be configuring the RTEP on our Edge clusters. What is an RTEP? Put simply an RTEP is a Remote Tunnel End Point.Just like the host and […]
NSX-T 3.0 Lab Single N-VDS Edge Nodes
Intro First off I apologize for the huge blog post, when I started writing this I didn’t think it would end up so long and splitting it into multiple parts just doesn’t seem right.When I deployed my Edge Nodes during my 2.4 lab build the recommended design approach was to deploy three N-VDS switches on […]
NSX-T 3.0 Lab: Changes to 3.0 Build
Intro If you followed my NSX-T 2.4 lab build guide series you’ll know I ran through a complete build of NSX-T on a single site including a Tier-0 and Tier-1 setup.Since I have now changed my lab to 3.0 I thought I’d make a post detailing the differences between building at version 3.0 vs 2.4 […]